Ring sizer
Printable Ring Sizer
Prior to printing, ensure that page scaling is set to “none” on your print dialog box (print at 100% and make sure that any "Fit to Page" check boxes are not checked).
Measure with a ruler any showed dimension below and compare. If the dimensions you measure do not match the one shown on this page then check again the print set up.
1. Measure finger with a paper ring sizer
- Cut out the ring sizer
- Cut a slit for slot "A"
- With the numbers facing out, wrap the sizer around the finger where the ring will be worn.
- Pull the pointed end "B" through slot "A" until the sizer is snug, making sure to allow size for the knuckle.
- The number aligned with slot "A" is your ring size.
- If the measure lands between two numbers your size is a half size. If half sizes are not available, order the next largest size.
2. Measure current ring (if you want to surprise her or him - as a gift)
- Select a ring that properly fits the intended finger. The “ring finger” is located between the little finger and middle finger. Engagement and wedding rings are traditionally worn on the ring finger on the left hand in US and Canada.
- Place the ring over the circles below, matching the inside edge of the ring to the circle nearest in size. This measurement refers to the diameter of the ring.
- If the ring falls between two sizes, order the larger size.
3. Dimensions and international conversion table
You are reading Ring sizer articles
